Painless Performance 2000 - 2002 GM VORTEC THROTTLE BY WIRE 60219 Manual do Utilizador Página 4

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 22
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 3
2.0 ABOUT THESE INSTRUCTIONS
These instructions provide information for the installation of the 60219 & 60220 TBW Vortec Fuel
Injection Harness Kit. The contents of these instructions are divided into major Sections, as follows:
1.0 INTRODUCTION
2.0 ABOUT THESE INSTRUCTIONS
3.0 TOOLS NEEDED
4.0 PRE-INSTALLATION AND HARNESS ROUTING GUIDELINES
5.0 GENERAL INSTALLATION INSTRUCTIONS
6.0 60219 or 60220 VORTEC FUEL INJECTION HARNESS KIT
7.0 GM 00-02 VORTEC SYSTEM WIRE HARNESS INSTALLATION
8.0 TROUBLE-SHOOTING INSTRUCTIONS
Sections are further divided into Paragraphs and Steps. Throughout, the Figure numbers refer to
illustration and the Table numbers refer to information in table form. These are located in or near
the sections or paragraphs to which they correspond. Always pay careful attention to any notes or
any text labeled CAUTION.
3.0 TOOLS NEEDED
In addition to your regular tools, you will need, at least, the following:
Crimping tool NOTE: USE A QUALITY TOOL TO AVOID OVER-CRIMPING.
Wire stripper
Continuity tester CAUTION: DO NOT USE A TEST LIGHT TO TEST THE COMPUTER OR
SENSOR WIRING OR YOU WILL DAMAGE THE COMPUTER.
Tech II or equivalent scanner (for presetting and diagnostic purposes)
Electric drill
1 5/8" Hole saw (for the rubber grommet in the firewall)
4.0 CONTENTS OF THE 60219 & 60220 WIRE HARNESS KIT
Take inventory to see that you have everything you are supposed to have in this kit, if
anything is missing, contact the dealer where you obtained the kit or contact Painless
Performance at (800) 423-9696 or (817) 244-6898.
The kit should contain the following items:
~ The main wire harness with the connectors already on the ends of most of the wires
~ Fuel Injection Installation Instructions P/N 90559 (This Booklet)
~ 4” & 7” tie wraps
~ TAC Module to Accelerator Pedal Pigtail
5.0 PRE-INSTALLATION AND HARNESS ROUTING GUIDELINES
The installation of your harness kit will consist of two parts:
~ The physical routing, positioning, securing, group/ individual wires and connectors.
~ The proper electrical connection of the individual circuits.
We cannot tell you how to route the harness in your automobile. That depends a great deal upon the
particular make of the automobile and what extent you want to secure and conceal the harness.
2
Vista de página 3
1 2 3 4 5 6 7 8 9 ... 21 22

Comentários a estes Manuais

Sem comentários