Painless Performance 2000 - 2002 GM VORTEC THROTTLE BY WIRE 60219 Manual do Utilizador

P/N 60219 & 60220 2000 - 2002 GM VORTEC THROTTLE BY WIRE FUEL INJECTION 4.8L, 5.3L & 6.0L WIRE HARNESS INSTALLATION INSTRUCTIONS Ma

E. FUSE BLOCK IGNITION - This circuit is used to provide power to the injection system. Connect this wire to a terminal/ wire from the ignition sw

FIGURE 7.3 Brake Switch Relay FIGURE 7.4 Cruise Control FIGURE 7.5 Fuel Pump Relay Connector 9

WIRE COLOR # OF WIRES LABELED CONNECT TO: IN CON

F. GROUND (mandatory) - These circuits are used to provide ground for the various devises. Connect these wires under a bolt in the engine block, t

WIRE COLOR # OF WIRES LABELED CONNECT TO:

FIGURE 7.8 Oxygen Sensor FIGURE 7.9 MAP Sensor FIGURE 7.10 CMP Sensor FIGURE 7.11 CKP Sensor FIGU

FIGURE 7.14 TPS Sensor FIGURE 7.15 TAC Motor FIGURE 7.16 MAF-IAT Sensor FIGURE 7.17 Driver Side Coil Connector

7.2 TAIL/TRANSMISSION GROUP INSTALLATION Locate the tail section that you earlier separated from the engine group. Begin routing it towards the r

WIRE COLOR # OF POSITIONS LABELED CONNECT TO: IN C

7.4 Converting the 4L60E Transmission Connector to a 4L80E Connector *Note: Harness numbers 60219 and 60220 have been wired for both the 4L60E an

TABLE OF CONTENTS 1.0 INTRODUCTION...

8.0 TROUBLE- SHOOTING INSTRUCTIONS FIGURE 8.1 Fuse Identification 8.1 THE "CHECK ENGINE" LIGHT Normally, the "check engine"

Before suspecting a computer problem, perform a careful visual inspection. Check under the hood for the same kinds of problems you would look for on

NOTES: 20

1.0 INTRODUCTION You have purchased what we at Painless Performance Products believe to be the most up-to-date and easiest-to-install automotive f

2.0 ABOUT THESE INSTRUCTIONS These instructions provide information for the installation of the 60219 & 60220 TBW Vortec Fuel Injection Harne

We do offer some general guidelines and routing practices starting in Paragraph 5.3, general installation instructions in Section 5.0, and precise

Table 5.1 Compatible Parts 5.2.8 Allow enough slack in the harness at places where movement could possibly occur (body to frame, frame to engine,

6.1.1 Connect a ground strap or cable (minimum of a 4 Ga. wire) from the negative battery terminal to the chassis (frame). 6.1.2 Connect a ground

6.4.1 Have all tools and connectors handy. 6.4.2 Select the correct terminal for the wire and application. 6.4.3 Determine the correct wire leng

7.0 GM 00 – 02 4.8L, 5.3L & 6.0L TBW VORTEC SYSTEM WIRE HARNESS INSTALLATION INSTRUCTIONS 7.1 DASH SECTION INSTALLATION Note: If you have n